ADM3491AN-1 vs ADM3491AN Comparaison
Comparaison détaillée côte à côte de ADM3491AN-1 par Analog Devices et ADM3491AN par Analog Devices. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Analog Devices
ADM3491AN-1 - 3.3V 20Mbps RS-485/RS-422 Transceiver | Analog Devices
ADM3491AN-1 ✓ ActifComparaison des spécifications
| Paramètre | ADM3491AN-1 | ADM3491AN |
|---|---|---|
| Marque | Analog Devices | Analog Devices |
| Catégorie | Interface ICs | Interface ICs |
| Statut du cycle de vie | Actif | Actif |
| Product Type | Low-power differential RS-485/RS-422 line transceiver | — |
| Tension d'alimentation | 3.3 V | 3.3 V ± 0.3 V |
| Maximum Data Rate | 20 Mbps | — |
| Low-Power Consumption | 840 uA | — |
| Supported Standards | EIA RS-485 and RS-422 | — |
| Communication Mode | Full duplex | — |
| Driver Architecture | Differential line driver | — |
| Receiver Architecture | Differential line receiver | — |
| Power-Down Feature | Yes, shutdown mode | — |
| Boîtier | 14-lead SOIC | 12-pin PDIP |
| Type de montage | Surface mount | Through-hole |
| Plage de température de fonctionnement | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature range] |
| Driver Enable Control | [DATA_NEEDED: driver enable polarity and timing] | — |
| Receiver Enable Control | [DATA_NEEDED: receiver enable polarity and timing] | — |
| Common-Mode Rejection | [DATA_NEEDED: receiver common-mode rejection] | — |
| Maximum Bus Length | [DATA_NEEDED: maximum cable length] | — |
| Statut RoHS | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS status] |
| REACH Status | [DATA_NEEDED: REACH status] | [DATA_NEEDED: REACH status] |
| Débit de données | — | 20 Mbps |
| Courant d'alimentation | — | 840 µA |
| Courant d'arrêt | — | 2 nA |
| Receiver Input Impedance | — | 19 kΩ |
| Maximum Transceivers on Bus | — | 50 transceivers |
| Duplex Mode | — | Full duplex |
| Interface Standards | — | EIA RS-485 and EIA RS-422 |
| Logic Compatibility | — | Interoperable with 5 V logic |
| Fault Protection | — | Short-circuit protection and thermal shutdown |
| Transient Immunity | — | IEC 1000-4-4 above 1 kV |
| Transmitter Skew | — | 8 ns |
| Lead-Free Status | — | [DATA_NEEDED: lead-free status] |