EPC2CC20N vs EPC21LC20 Comparaison
Comparaison détaillée côte à côte de EPC2CC20N par Altera et EPC21LC20 par Intel. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Comparaison des spécifications
| Paramètre | EPC2CC20N | EPC21LC20 |
|---|---|---|
| Marque | Altera | Intel |
| Catégorie | FPGA & CPLD | Memory ICs |
| Statut du cycle de vie | NRND | Actif |
| Statut du stock | In Stock | In Stock |
| Prix unitaire (USD) | $10,85 | $10,40 |
| Fonction | Configuration device for SRAM-based LUT FPGAs | — |
| Density | [DATA_NEEDED: bitstream density in bits] | 2 Mb (2,097,152 bits) |
| Boîtier | PLCC-20 | — |
| Configuration Interface | 16-bit parallel (FPP) / Passive Serial (PS) | — |
| Supply Voltage (VCC) | 3.3 V | — |
| Programming Interface | JTAG (IEEE 1149.1) via ByteBlasterMV / USB-Blaster | IEEE 1149.1 (JTAG) |
| In-System Programmable | Yes | — |
| Error Detection | 16-bit CRC on configuration frames | — |
| Configuration Modes Supported | FPP and PS (depends on host FPGA) | — |
| Cascadable | Yes (multiple EPC2 devices for larger bitstreams) | — |
| Open-Drain Status Pin | Yes (CONF_DONE / nSTATUS compatible) | — |
| Température de fonctionnement | [DATA_NEEDED: industrial/commercial temp range] | — |
| Type de montage | Surface Mount (PLCC-20 socket compatible) | Surface Mount (PLCC socket or solder) |
| Niveau MSL | [DATA_NEEDED: MSL rating] | [DATA_NEEDED: confirm moisture sensitivity level] |
| Statut RoHS | [DATA_NEEDED: RoHS compliance status] | [DATA_NEEDED: confirm from Altera product page] |
| Type de mémoire | — | Serial Configuration PROM (Flash-based, in-system programmable) |
| Configuration Mode Supported | — | Serial (PS) for Altera SRAM-based LUT FPGAs |
| Maximum DCLK Frequency | — | 10 MHz |
| Access Time | — | approximately 35 ns [DATA_NEEDED: confirm exact datasheet figure] |
| Program/Erase Endurance | — | 100 cycles minimum [DATA_NEEDED: confirm from datasheet] |
| Operating Voltage (VCC) | — | 3.0 V to 3.6 V (3.3 V typical) |
| Standby Current | — | [DATA_NEEDED: ICCSB value] |
| Active Read Current | — | [DATA_NEEDED: ICC active current] |
| Operating Temperature (commercial) | — | 0 °C to +70 °C (LC suffix) |
| Operating Temperature (industrial) | — | [DATA_NEEDED: -40 to +85 °C for LI variant] |
| Boîtier / Format | — | 20-pin PLCC (J-lead, JEDEC MS-018) |
| Lead-Free (Pb-free) | — | [DATA_NEEDED: confirm] |
| Compatible FPGA Families | — | ACEX, APEX, Cyclone, FLEX, Mercury, Stratix (SRAM-based LUT) |
| JTAG Boundary-Scan Compliant | — | Yes (IEEE Std 1149.1) |
| Data Width | — | 1 bit (serial DATA output) |