EPC1441PI8N vs EPC1441PCB Perbandingan
Perbandingan bersamaan detil EPC1441PI8N dari Altera dan EPC1441PCB dari Altera. Bandingkan spesifikasi penting, parameter listrik, pengemasan, status cycle, harga, dan ketersediaan untuk menentukan komponen terbaik untuk kebutuhan desain Anda.
Altera
EPC1441PI8N - 440Kb OTP Config PROM, 8-PDIP | Altera / Intel
EPC1441PI8N ⚠ Waktu Beli Terakhir
Perbandingan Spesifikasi
| Parameter Umum | EPC1441PI8N | EPC1441PCB |
|---|---|---|
| Merek | Altera | Altera |
| Kategori | Memory ICs | FPGA & CPLD |
| Status Lingkungan Hidup | Waktu Pembelian Terakhir | Obsolete |
| Tipe Memori | OTP Configuration PROM (poly-fuse) | — |
| Memory Capacity | 440,800 bits (440 Kbit) | — |
| Configuration Interface | Altera Serial (PS) configuration | Altera serial/parallel configuration bus (nSTATUS, nCONFIG, DCLK, DATA) |
| Supply Voltage VCC | 5.0 V nominal (4.75 V to 5.25 V) | — |
| Active Supply Current ICC | [DATA_NEEDED: typical active ICC] | — |
| Standby Supply Current ICCSTBY | approximately 50 uA | — |
| Programming Method | Off-board PROM programmer (poly-fuse OTP) | — |
| Configuration Time | <100 ms typical for FLEX10KA loading | — |
| Suhu Kerja | -40C to +85C (industrial) | 0 C to +70 C (commercial) |
| Paket | 8-pin PDIP (Plastic DIP, through-hole) | PLCC-20 (Plastic Leaded Chip Carrier) |
| Jumlah Pin | 8 | — |
| Tipe Mounting | Through-hole (THT) | Surface Mount / Socket |
| Lead-Free / RoHS | Non-RoHS (legacy through-hole); check suffix for Pb-free option | — |
| Compatible FPGA Families | FLEX10K, FLEX10KA, FLEX6000, APEX20K series | — |
| Family Position | Top-of-family (largest density: 440Kb) | — |
| Programming Voltage | [DATA_NEEDED: VPP programming voltage] | — |
| Endurance | One-time programmable (no reprogram cycles) | — |
| Device Type | — | Enhanced Configuration Device for SRAM FPGAs |
| Memory Density | — | 4,435,200 bits (~4 Mb) |
| Supported FPGA Families | — | ACEX 1K, APEX 20K, APEX II, FLEX 10K, FLEX 6000, FLEX 8000, Mercury |
| Programmability | — | In-system programmable via JTAG (IEEE 1149.1) |
| Supply Voltage (VCC) | — | 3.3 V nominal |
| I/O Voltage Tolerance | — | 5 V tolerant |
| Configuration Mode | — | Automatic at power-up |
| Architecture | — | Flash memory + on-chip configuration controller |
| JTAG Support | — | Yes (IEEE 1149.1 boundary scan) |
| Status RoHS | — | [DATA_NEEDED: RoHS compliance status] |
| Lead-Free | — | [DATA_NEEDED: lead-free status] |