EPC1441PI8N vs EPC1441PCB Pengandingan
Pengandingan Sisi Kiri Sisi Kanan Terperinci EPC1441PI8N disebabkan oleh Altera dan EPC1441PCB disebabkan oleh Altera. Bandingkan spesifikasi utama, parameter elektrik, pakej, status kehidupan, harga, dan keupayaan untuk menentukan komponen terbaik untuk keperluan disenjaya anda.
Altera
EPC1441PI8N - 440Kb OTP Config PROM, 8-PDIP | Altera / Intel
EPC1441PI8N ⚠ Bahagian terakhir untuk beli
Pengandingan Spesifikasi
| Parametr | EPC1441PI8N | EPC1441PCB |
|---|---|---|
| Merek | Altera | Altera |
| Kategori | Memory ICs | FPGA & CPLD |
| Status Lingkungan Hidup | Masa Terakhir Dibeli | Obsolete |
| Jenis Ingatan | OTP Configuration PROM (poly-fuse) | — |
| Memory Capacity | 440,800 bits (440 Kbit) | — |
| Configuration Interface | Altera Serial (PS) configuration | Altera serial/parallel configuration bus (nSTATUS, nCONFIG, DCLK, DATA) |
| Supply Voltage VCC | 5.0 V nominal (4.75 V to 5.25 V) | — |
| Active Supply Current ICC | [DATA_NEEDED: typical active ICC] | — |
| Standby Supply Current ICCSTBY | approximately 50 uA | — |
| Programming Method | Off-board PROM programmer (poly-fuse OTP) | — |
| Configuration Time | <100 ms typical for FLEX10KA loading | — |
| Suhu Operasi | -40C to +85C (industrial) | 0 C to +70 C (commercial) |
| Kemasan | 8-pin PDIP (Plastic DIP, through-hole) | PLCC-20 (Plastic Leaded Chip Carrier) |
| Kiraan Pin | 8 | — |
| Jenis Pemasangan | Through-hole (THT) | Surface Mount / Socket |
| Lead-Free / RoHS | Non-RoHS (legacy through-hole); check suffix for Pb-free option | — |
| Compatible FPGA Families | FLEX10K, FLEX10KA, FLEX6000, APEX20K series | — |
| Family Position | Top-of-family (largest density: 440Kb) | — |
| Programming Voltage | [DATA_NEEDED: VPP programming voltage] | — |
| Endurance | One-time programmable (no reprogram cycles) | — |
| Device Type | — | Enhanced Configuration Device for SRAM FPGAs |
| Memory Density | — | 4,435,200 bits (~4 Mb) |
| Supported FPGA Families | — | ACEX 1K, APEX 20K, APEX II, FLEX 10K, FLEX 6000, FLEX 8000, Mercury |
| Programmability | — | In-system programmable via JTAG (IEEE 1149.1) |
| Supply Voltage (VCC) | — | 3.3 V nominal |
| I/O Voltage Tolerance | — | 5 V tolerant |
| Configuration Mode | — | Automatic at power-up |
| Architecture | — | Flash memory + on-chip configuration controller |
| JTAG Support | — | Yes (IEEE 1149.1 boundary scan) |
| Status RoHS | — | [DATA_NEEDED: RoHS compliance status] |
| Lead-Free | — | [DATA_NEEDED: lead-free status] |