NE5532AP vs NE5532N 比較
詳細な並列比較: NE5532AP メーカー: Texas Instruments および NE5532N メーカー: onsemi。主要仕様、電気的特性、パッケージ、ライフサイクルステータス、価格、在庫状況を比較して、設計要件に最適な部品を判断してください。
Texas Instruments
NE5532AP - Dual Low-Noise Op Amp, 10MHz, 8-PDIP | Texas Instruments
NE5532AP ✓ 生産中仕様比較
| パラメータ | NE5532AP | NE5532N |
|---|---|---|
| ブランド | Texas Instruments | onsemi |
| カテゴリ | Amplifier ICs | Amplifier ICs |
| ライフサイクル状態 | 有効 | Unknown |
| Manufacturer | Texas Instruments | — |
| Part Number | NE5532AP | — |
| Amplifier Type | Low-Noise Operational Amplifier | General Purpose |
| Number of Channels | 2 (Dual) | — |
| パッケージ / ケース | 8-PDIP (through-hole, 2.54 mm pitch) | — |
| Supply Voltage (Dual) | ±5 V to ±15 V (max ±18 V) | — |
| Unity-Gain Bandwidth | 10 MHz (typ.) | — |
| Equivalent Input Noise Voltage | 5 nV/√Hz (typ. at 1 kHz) | — |
| Slew Rate | [DATA_NEEDED: slew rate V/us] | 9 V/µs |
| Common-Mode Rejection Ratio (CMRR) | 100 dB (typ.) | — |
| DC Voltage Gain | 100 V/mV (typ., 100 dB) | — |
| Peak-to-Peak Output Swing | 32 V typ. (VCC± = ±18 V, RL = 600 ohm) | — |
| Output Drive | 600 ohm loads (typ.) | Improved output-drive capability |
| Input Protection | Input-protection diodes | — |
| Output Protection | Output short-circuit protection | — |
| 動作温度範囲 | 0 °C to +70 °C (NE5532x commercial) | [DATA_NEEDED: operating temperature range] |
| 実装タイプ | Through-Hole (PDIP) | — |
| RoHS ステータス | Compliant (Pb-free) | — |
| Product Type | — | Dual internally compensated operational amplifier |
| Number of Circuits | — | 2 |
| パッケージ | — | 8-PDIP (0.300 in, 7.62 mm) |
| Packaging | — | Tube |
| Gain Bandwidth Product | — | 10 MHz |
| Compensation | — | Internal frequency compensation |
| Noise Performance | — | Low noise |
| Small-Signal Bandwidth | — | High small-signal bandwidth |
| Power Bandwidth | — | High power bandwidth |
| 実装スタイル | — | Through-hole |
| 電源電圧 | — | [DATA_NEEDED: supply voltage] |
| Input Offset Voltage | — | [DATA_NEEDED: input offset voltage] |
| Input Bias Current | — | [DATA_NEEDED: input bias current] |
| Input Noise Density | — | [DATA_NEEDED: input noise density] |
| Output Current | — | [DATA_NEEDED: output current] |