NE5532AP vs NE5532N 比較
詳細並排比較 NE5532AP 由 Texas Instruments 與 NE5532N 由 onsemi. 比較關鍵規格、電氣參數、封裝、生命週期狀態、價格與供貨情況，以找出最符合您設計需求的元件。
Texas Instruments
NE5532AP - Dual Low-Noise Op Amp, 10MHz, 8-PDIP | Texas Instruments
NE5532AP ✓ 啟用中規格比較
| 參數 | NE5532AP | NE5532N |
|---|---|---|
| 品牌 | Texas Instruments | onsemi |
| 類別 | Amplifier ICs | Amplifier ICs |
| 生命週期狀態 | 啟用中 | Unknown |
| Manufacturer | Texas Instruments | — |
| Part Number | NE5532AP | — |
| Amplifier Type | Low-Noise Operational Amplifier | General Purpose |
| Number of Channels | 2 (Dual) | — |
| 封裝 / 外殼 | 8-PDIP (through-hole, 2.54 mm pitch) | — |
| Supply Voltage (Dual) | ±5 V to ±15 V (max ±18 V) | — |
| Unity-Gain Bandwidth | 10 MHz (typ.) | — |
| Equivalent Input Noise Voltage | 5 nV/√Hz (typ. at 1 kHz) | — |
| Slew Rate | [DATA_NEEDED: slew rate V/us] | 9 V/µs |
| Common-Mode Rejection Ratio (CMRR) | 100 dB (typ.) | — |
| DC Voltage Gain | 100 V/mV (typ., 100 dB) | — |
| Peak-to-Peak Output Swing | 32 V typ. (VCC± = ±18 V, RL = 600 ohm) | — |
| Output Drive | 600 ohm loads (typ.) | Improved output-drive capability |
| Input Protection | Input-protection diodes | — |
| Output Protection | Output short-circuit protection | — |
| 工作溫度範圍 | 0 °C to +70 °C (NE5532x commercial) | [DATA_NEEDED: operating temperature range] |
| 安裝類型 | Through-Hole (PDIP) | — |
| RoHS 狀態 | Compliant (Pb-free) | — |
| Product Type | — | Dual internally compensated operational amplifier |
| Number of Circuits | — | 2 |
| 封裝 | — | 8-PDIP (0.300 in, 7.62 mm) |
| Packaging | — | Tube |
| Gain Bandwidth Product | — | 10 MHz |
| Compensation | — | Internal frequency compensation |
| Noise Performance | — | Low noise |
| Small-Signal Bandwidth | — | High small-signal bandwidth |
| Power Bandwidth | — | High power bandwidth |
| 安裝方式 | — | Through-hole |
| 供應電壓 | — | [DATA_NEEDED: supply voltage] |
| Input Offset Voltage | — | [DATA_NEEDED: input offset voltage] |
| Input Bias Current | — | [DATA_NEEDED: input bias current] |
| Input Noise Density | — | [DATA_NEEDED: input noise density] |
| Output Current | — | [DATA_NEEDED: output current] |