LM393AM vs LM293AM 비교
다음의 상세 나란히 비교: LM393AM 제조: onsemi 및 LM293AM 제조: onsemi. 주요 사양, 전기적 파라미터, 패키징, 수명 주기 상태, 가격 및 재고를 비교하여 설계 요구 사항에 가장 적합한 부품을 결정하십시오.
사양 비교
| 파라미터 | LM393AM | LM293AM |
|---|---|---|
| 브랜드 | onsemi | onsemi |
| 카테고리 | Amplifier ICs | Amplifier ICs |
| 수명 주기 상태 | 활성 | 활성 |
| Comparator Type | Dual differential comparator | Dual differential comparator |
| Number of Channels | 2 channels | 2 channels |
| Single-Supply Operating Voltage | 36 V maximum | — |
| Dual-Supply Operating Voltage | ±18 V maximum | — |
| Current Drain | 800 µA typical | — |
| Input Bias Current | 25 nA typical | — |
| 출력 유형 | Open collector | Open-collector, open-drain |
| Logic Compatibility | Compatible with all forms of logic | Compatible with TTL, MOS, and CMOS logic |
| Ground-Level Comparison | Supported | — |
| 패키지 | 8-SOIC | 8-pin SOIC |
| Package Width | 3.90 mm (0.154 inch) | — |
| 실장 유형 | Surface mount | Surface mount |
| Input Offset Voltage | [DATA_NEEDED: input offset voltage] | [DATA_NEEDED: input offset voltage] |
| Input Common-Mode Voltage Range | [DATA_NEEDED: input common-mode voltage range] | — |
| Output Sink Current | [DATA_NEEDED: output sink current] | [DATA_NEEDED: output sink current] |
| Propagation Delay | [DATA_NEEDED: propagation delay] | — |
| 동작 온도 범위 | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature range] |
| RoHS 상태 | unknown | [DATA_NEEDED: RoHS status] |
| REACH Status | unknown | — |
| AEC-Q100 Qualification | not_applicable | — |
| Single-Supply Operating Range | — | Up to 36 V |
| Dual-Supply Operating Range | — | Up to ±18 V |
| Typical Low Current Drain | — | 800 µA |
| Typical Input Bias Current | — | 25 nA |
| Common-Mode Input Capability | — | Comparison of voltages near ground potential |
| 공급 전류 | — | [DATA_NEEDED: maximum supply current] |
| Common-Mode Input Voltage Range | — | [DATA_NEEDED: common-mode input voltage range] |
| Differential Input Voltage Range | — | [DATA_NEEDED: differential input voltage range] |
| Output Saturation Voltage | — | [DATA_NEEDED: output saturation voltage] |
| Response Time | — | [DATA_NEEDED: comparator response time] |