LM339DG4 vs LM339MX Ikinahambing
Detalyadong pagkakahiwalay na pagkakahambing ng LM339DG4 sa pamamagitan ng Texas Instruments at LM339MX sa pamamagitan ng Texas Instruments. Ikinahambing ang mga pangunahing paglalarawan, mga tama ng elektriko, paakay, kalagayan ng buhay, presyo, at pagkakaroon upang makita ang pinakamahusay na komponente para sa iyong mga kinakailangang pang disenyo.
Pagsanggunian na paghahambing
| Parametro | LM339DG4 | LM339MX |
|---|---|---|
| Brand | Texas Instruments | Texas Instruments |
| Kategorya | Amplifier ICs | Amplifier ICs |
| Katayuan ng Lifecycle | Aktibo | Aktibo |
| Comparator Type | 4-channel differential comparator | General Purpose |
| Type ng Output | Open collector | Open-Collector |
| Supply Voltage Range | 2 V to 36 V | Approximately 36 V total, or approximately ±18 V |
| Maximum Rating | Up to 38 V | — |
| Number of Channels | 4 | — |
| Input Offset Voltage | 0.37 mV | [DATA_NEEDED: input offset voltage] |
| Input Bias Current | 3.5 nA | — |
| Kuru-kuryente ng Pagbibigay | 200 uA per comparator | [DATA_NEEDED: supply current] |
| Response Time | 300 ns | 1.3 µs |
| ESD Rating | 2 kV HBM | — |
| Hanay ng Temperature na Operasyon | 0 °C to 70 °C | 0 °C to 70 °C |
| Packhaging | 14-pin SOIC | 14-pin SOIC |
| Uri ng Pagpapasok | Surface mount | Surface Mount |
| Single-Supply Operation | Supported | — |
| Dual-Supply Operation | Supported | — |
| Output Pull-Up Requirement | External pull-up resistor required | — |
| Tindminan RoHS | unknown | [DATA_NEEDED: RoHS status] |
| REACH Status | unknown | — |
| Number of Comparators | — | 4 |
| Single or Dual Supply Operation | — | Supported |
| Output Compatibility | — | TTL, CMOS, MOS, DTL, and ECL |
| Bilang ng Pins | — | 14 |
| Channel Independence | — | 4 independent comparators |
| Common-Mode Input Voltage Range | — | [DATA_NEEDED: common-mode input voltage range] |
| Differential Input Voltage Range | — | [DATA_NEEDED: differential input voltage range] |
| Output Sink Current | — | [DATA_NEEDED: output sink current] |
| Output Saturation Voltage | — | [DATA_NEEDED: output saturation voltage] |
| Pull-Up Resistor | — | [DATA_NEEDED: recommended pull-up resistor] |