A54SX32-BGG329I - 32K-Gate SX FPGA, 249 I/O, 329-BGA | Microchip
料号： A54SX32-BGG329I ✓ 量产中| 数量 | 单价 | 小计 |
|---|---|---|
| 1 | $0 | $0.00 |
| 10 | $0 | $0.00 |
| 100 | $0 | $0.00 |
| 500 | $0 | $0.00 |
| 1,000 | $0 | $0.00 |
A54SX32-BGG329I 概述
A Field-Programmable Gate Array (FPGA) is a user-configurable integrated circuit whose internal logic is defined after manufacturing rather than fixed at the fab. Within the semiconductor hierarchy, an FPGA sits above fixed-function logic (CPLD, standard logic) and below ASICs in volume economics: it offers ASIC-like integration without mask costs or NRE. The Actel SX family uses a sea-of-modules architecture built on antifuse programmable interconnect, which is one-time programmable but keeps configuration data non-volatile and resistant to readback.
Key differentiating specifications include 320 MHz internal toggle-class performance, 3.7 ns pin-to-pin clock-to-out, 0.1 ns input setup time, and 0.25 ns clock skew - timing figures that allow the SX32 to replace multi-chip CPLD/FPGA combinations and to implement 66 MHz PCI logic in a single-chip solution. The 0.35 um CMOS process supports dual 3.3V core / 5V tolerant I/O operation.
Architecturally, the SX family's sea-of-modules structure eliminates the long routing delays typical of channel-based FPGAs, so timing is predictable and largely independent of placement. Because antifuse interconnect adds no configuration cell capacitance in the signal path, the device achieves performance-intensive operation at reduced power versus SRAM FPGAs of comparable capability, and its design is inherently secure since no bitstream is stored on chip.
Typical applications include 66 MHz PCI bus interfaces, industrial control and automation, aerospace and defense logic integration (where the I-grade industrial variant is common), communications line cards, and single-chip glueless integration of previously discrete CPLD and FPGA functions.
Design consideration: antifuse FPGAs are one-time programmable, so logic must be verified thoroughly in simulation with Actel (Microchip) Libero-style toolchains before programming; there is no in-system reconfiguration as with SRAM FPGAs.
This page adds information gain over the manufacturer datasheet by consolidating distributor pricing context, same-footprint BGA variant alternatives from the Microchip SX family, engineering design notes, and an FAQ set optimized for quick engineering answers.
直接替换替代料： A54SX32-BGG329I ——相同封装，引脚兼容。需要 PCB 改动的不同封装料号已排除。
本系列中的变体
可与以下型号直接替换的同系列型号： A54SX32-BGG329I （相同外形与封装尺寸） ——差异在于 Package, Family, System Gates, RoHS Status, Supply Voltage.
快速对比工具——选择替代料号进行并排对比：
A54SX32-1BGG329I
✅ 直接替换✓ 有现货
$47.8 / 个
查看数据手册 →A54SX32-2BGG329I
✅ 直接替换✓ 有现货
$88.9 / 个
查看数据手册 →A54SX32-BGG329
✅ 直接替换✓ 有现货
$515.58 / 个
查看数据手册 →A54SX32-1BGG329
✅ 直接替换✓ 有现货
$544.99 / 个
查看数据手册 →A54SX32-2BGG329
✅ 直接替换✓ 有现货
联系询价
查看数据手册 →A54SX32A-BGG329
✅ 直接替换📋 参考替代料（不在目录中）
A54SX32-BGG329I 最大额定值与电气特性
| System Gates | 32000 |
| Logic Cells / Logic Modules | 2880 |
| User I/O | 249 |
| Internal System Performance | 320 MHz |
| Internal Operating Frequency | 240 MHz |
| Clock-to-Out (Pin-to-Pin) | 3.7 ns |
| Input Setup Time | 0.1 ns |
| Clock Skew | 0.25 ns |
| PCI Interface Support | 66 MHz PCI |
| Process Technology | 0.35 um CMOS |
| 电源电压 | 3.3 V core / 5 V I/O |
| Logic Family | CMOS |
| Programmable Interconnect | Antifuse (one-time programmable) |
| 封装 | 329-Ball BGA (329-BBGA) |
| 安装类型 | Surface Mount |
| Architecture | Sea-of-modules, Actel SX family |
A54SX32-BGG329I 329-ball bga (329-bbga) 引脚配置指南
A54SX32-BGG329I（329-ball bga (329-bbga) 封装）的引脚配置。 该数字 IC 包含 GPIO、通信接口（UART、SPI、I2C）和电源引脚。请参阅制造商数据手册以了解复用引脚功能和配置选项。对嵌入式系统设计和 PCB 布局至关重要。
暂无详细引脚数据： A54SX32-BGG329I.
请参阅 数据手册 以查看完整引脚配置。
典型应用
A54SX32-BGG329I 适用于 6 应用s: 66 MHz PCI Bus Interface, Industrial Control and Automation, Aerospace and Defense Logic Integration, Communications Line Cards, CPLD and FPGA Consolidation (Single-Chip Integration), Secure and Instant-On Embedded Systems.
66 MHz PCI Bus Interface
The A54SX32-BGG329I implements single-chip 66 MHz PCI interfaces thanks to 0.1 ns input setup time, 0.25 ns clock skew, and 3.7 ns pin-to-pin clock-to-out. The sea-of-modules architecture gives deterministic routing delays, so the tight PCI timing budget closes reliably without place-and-route iterations. In a typical design the FPGA hosts the PCI state machines, target/initiator logic, and application glue logic across its 249 user I/O, integrating what previously required a CPLD plus FPGA. Because the antifuse interconnect is non-volatile, the PCI board powers up already configured - no host-side configuration controller or boot flash is needed, improving bus bring-up time and system availability.
推荐
Industrial Control and Automation
Industrial controllers benefit from the A54SX32-BGG329I's industrial temperature grade (I suffix), 5V-tolerant I/O, and non-volatile antifuse configuration. Legacy factory equipment commonly runs 5V logic; the SX32's dual 3.3V core / 5V I/O operation lets it interface directly with older PLC I/O modules and sensors without level shifters. Its 32,000 gates and 2,880 logic cells integrate sequencers, counters, and interface logic that once required multiple 22V10-class CPLDs. Because the configuration cannot be read back or disturbed by power glitches, the device suits noisy motor-control cabinets and systems where an SRAM FPGA's configuration upset or missing boot image would halt production.
推荐
Aerospace and Defense Logic Integration
The antifuse SX architecture has long been favored in aerospace and defense payloads for configuration security and latch-up-resistant operation. The A54SX32-BGG329I's one-time-programmable interconnect leaves no readable bitstream in the system, supporting design IP protection for mission hardware, and there is no configuration memory to upset in radiation environments (for full rad-tolerance Microchip offers the related RTAX family). Designers use the 32K gates to integrate telemetry formatting, bus bridges, and redundancy/voting logic in a single 329-BBGA. Instant-on behavior means FPGA-based sequencers are active within nanoseconds of power application - valuable in payload power-switching and safe-and-arm style subsystems.
推荐
Communications Line Cards
Telecom and datacom line cards use the A54SX32-BGG329I for framing, multiplexing, and backplane interface logic. The 240 MHz internal operating frequency supports high-throughput serial-to-parallel conversion at line rates, while 249 I/O accommodate wide parallel backplanes. The sea-of-modules routing keeps timing closure predictable across design revisions - important when a line card must pass compliance across multiple builds. Its 5V-tolerant I/O eases interoperation with legacy 5V backplane standards common in installed chassis. Because the device configures itself from antifuse state at power-up, hot-swappable cards resume operation immediately without a configuration controller consuming board area.
推荐
CPLD and FPGA Consolidation (Single-Chip Integration)
The SX family datasheet explicitly markets the A54SX32 as a single-chip solution for CPLD and FPGA integration, and this cost-reduction role is its most common use. Boards that combined a fast CPLD for decode/state machines with a mid-range FPGA for datapath logic can consolidate both functions into one A54SX32-BGG329I, saving a device position, two assembly steps, and the inter-device routing that degraded timing. The 320 MHz internal performance and 0.25 ns clock skew support the decode logic traditionally done in CPLDs, while 32K gates handle the datapath. For legacy redesigns, consolidating into one BGA also improves board reliability by removing one solder-joint-heavy package.
推荐
Secure and Instant-On Embedded Systems
Systems that must be active within microseconds of power and must not expose their configuration - payment terminals, secure comm units, anti-tamper subsystems - fit the A54SX32-BGG329I's antifuse profile. Unlike SRAM FPGAs that fetch a bitstream from external flash (a visible, interceptable image), the antifuse pattern is physically programmed at the factory or programming station and cannot be read back. The device draws no configuration current and has no boot latency, so mission-critical control logic, key handling state machines, or watchdog functions implemented in the SX32 are live before a software processor finishes reset. The 329-BBGA also resists casual probing relative to smaller-pitch packages.
推荐
推荐产品汇总
工程参考数据： A54SX32-BGG329I ——对比、设计指导和合规信息。
选型指南
与替代料对比
| 参数 | 本产品 | A54SX32-1BGG329I | A54SX32-2BGG329I | A54SX32-BGG329 | A54SX32-1BGG329 | A54SX32-2BGG329 | A54SX32A-BGG329 |
|---|---|---|---|---|---|---|---|
| Package | 329-BBGA | 329-BBGA - same | 329-BBGA - same | 329-BBGA - same | 329-BBGA - same | 329-BBGA - same | 329-BBGA - same |
| Brand | Microchip Technology (Microsemi/Actel) | Microchip Technology | Microchip Technology | Microchip Technology | Microchip Technology | Microchip Technology | Microchip Technology |
| System Gates | 32000 | 32000 | 32000 | 32000 | 32000 | 32000 | 32000-class SX-A die |
| Logic Cells | 2880 | 2880 | 2880 | 2880 | 2880 | 2880 | 2880 |
| User I/O | 249 | 249 | 249 | 249 | 249 | 249 | 249 |
| Temperature Grade | Industrial (I) | Industrial (I) | Industrial (I) | Commercial | Commercial | Commercial | Commercial |
| Interconnect Technology | Antifuse (OTP) | Antifuse (OTP) | Antifuse (OTP) | Antifuse (OTP) | Antifuse (OTP) | Antifuse (OTP) | Antifuse (OTP) |
关键差异点
- Industrial temperature qualification with full 249 I/O in 329-BBGA （对比 A54SX32-BGG329)
- Guaranteed higher timing grades for timing-critical PCI logic （对比 A54SX32-1BGG329I)
- Deterministic one-time-programmable antifuse with configuration security （对比 A54SX32A-BGG329 (SX-A))
设计说明
The A54SX32-BGG329I is one-time programmable: once programmed, the device cannot be erased or reconfigured. Always exhaust simulation, static timing analysis, and (where possible) a programmed sample validation before committing production units. Program a small pilot lot first - a logic error discovered after programming all stock means scrapping the entire lot. Reserve I/O and internal routing margin in your design so small bug fixes can sometimes be routed around without changing the pinout, but do not rely on this as a substitute for thorough verification.
For the 329-ball BGA, obtain the exact ball-map and mechanical drawing from the Microchip SX family datasheet and generate the footprint from the Libero/Designer pin report rather than third-party diagrams - I/O bank assignments are user-definable and the datasheet pin tables show function, not a fixed netlist. Follow manufacturer guidance for via-in-pad or dogbone fanout with 1.27 mm-class BGA pitch, and place 0.1 uF decoupling capacitors for each supply ball group as close as routing allows. Define unused I/O as grounded per datasheet recommendations to avoid floating inputs.
The device operates from 3.3V core with 5V-tolerant I/O per the SX family datasheet. Estimated: power dissipation depends heavily on toggle rates, so use the Microchip power calculator (or Designer tool power estimator) with your actual netlist rather than rule-of-thumb numbers. Supply both rails in the correct sequence per the datasheet power-up specification, and verify that 5V-domain inputs never exceed the absolute maximum ratings during transients. A solid ground plane under the BGA is required for both power integrity and the 0.25 ns clock-skew figure at 66 MHz PCI operation.
At 66 MHz PCI and 240 MHz internal operation, match trace lengths on the PCI clock and control group and follow the PCI SIG layout guidelines for loading (maximum trace length and capacitance per PCI revision). The SX32's 0.1 ns setup and 0.25 ns skew figures give generous internal margin, but board-level reflections can still violate receiver thresholds - terminate per the PCI specification and simulate stubs on the 329-BBGA breakout fanout, which adds inductive stubs if vias are placed far from the balls.
合规信息
Third-party specification records list the BGG329 package family as ROHS COMPLIANT plastic BGA. REACH, lead-free, halogen-free, and conflict-minerals status were not stated in the verified web data - confirm certificates with Microchip before BOM release.
