ADM485ARZ vs ADM485AR Comparaison
Comparaison détaillée côte à côte de ADM485ARZ par Analog Devices et ADM485AR par Analog Devices. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
Analog Devices
ADM485ARZ - 5V 5Mbps Half-Duplex RS-485/RS-422 Transceiver | Analog Devices (Tape & Reel)
ADM485ARZ ✓ ActifComparaison des spécifications
| Paramètre | ADM485ARZ | ADM485AR |
|---|---|---|
| Marque | Analog Devices | Analog Devices |
| Catégorie | Interface ICs | Interface ICs |
| Statut du cycle de vie | Actif | Actif |
| Type | Transceiver | — |
| Protocol | RS-422, RS-485 | — |
| Number of Drivers/Receivers | 1/1 | — |
| Duplex | Half | — |
| Tension d'alimentation | 5 V (single supply) | 5 V |
| Débit de données | 5 Mbps (max) | — |
| Receiver Hysteresis | [DATA_NEEDED: receiver hysteresis] | — |
| Common-Mode Range | -7 V to +12 V | — |
| Driver Differential Output | [DATA_NEEDED: VOD min/max] | — |
| Plage de température de fonctionnement | -40 C to +85 C | [DATA_NEEDED: operating temperature range] |
| Boîtier | SOIC-8 (SO-8) / SO-8 | 8-pin SOIC |
| Type de montage | Surface Mount | [DATA_NEEDED: surface-mount or through-hole mounting] |
| ESD Protection | [DATA_NEEDED: ESD HBM rating] | [DATA_NEEDED: ESD protection rating] |
| Statut RoHS | Compliant | — |
| REACH Status | Unaffected | — |
| Niveau MSL | 1 (Unlimited) | — |
| Compliance | ROHS3 Compliant | — |
| Enable Pins | Yes (DE driver enable, RE receiver enable, active-low/GPIO logic) | — |
| Product Type | — | Differential line transceiver |
| Supported Standards | — | EIA RS-485 and RS-422 |
| Driver Count | — | 1 |
| Receiver Count | — | 1 |
| Communication Mode | — | High-speed bidirectional |
| Bus Architecture | — | Multipoint balanced transmission line |
| Driver and Receiver Enable | — | Driver and receiver can be enabled |
| Signal Type | — | Differential balanced signaling |
| Logic Interface | — | [DATA_NEEDED: logic input and output voltage levels] |
| Maximum Data Rate | — | [DATA_NEEDED: maximum data rate] |
| Differential Driver Output | — | [DATA_NEEDED: differential output voltage and current] |
| Receiver Sensitivity | — | [DATA_NEEDED: receiver sensitivity] |
| Common-Mode Voltage Range | — | [DATA_NEEDED: common-mode voltage range] |
| Propagation Delay | — | [DATA_NEEDED: propagation delay] |
| RoHS | — | unknown |
| REACH | — | unknown |
| AEC-Q100 | — | unknown |