ADM485ARZ vs ADM485AR Ikinahambing
Detalyadong pagkakahiwalay na pagkakahambing ng ADM485ARZ sa pamamagitan ng Analog Devices at ADM485AR sa pamamagitan ng Analog Devices. Ikinahambing ang mga pangunahing paglalarawan, mga tama ng elektriko, paakay, kalagayan ng buhay, presyo, at pagkakaroon upang makita ang pinakamahusay na komponente para sa iyong mga kinakailangang pang disenyo.
Analog Devices
ADM485ARZ - 5V 5Mbps Half-Duplex RS-485/RS-422 Transceiver | Analog Devices (Tape & Reel)
ADM485ARZ ✓ NakahandaPagsanggunian na paghahambing
| Parametro | ADM485ARZ | ADM485AR |
|---|---|---|
| Brand | Analog Devices | Analog Devices |
| Kategorya | Interface ICs | Interface ICs |
| Katayuan ng Lifecycle | Aktibo | Aktibo |
| Type | Transceiver | — |
| Protocol | RS-422, RS-485 | — |
| Number of Drivers/Receivers | 1/1 | — |
| Duplex | Half | — |
| Volte ng Pagbibigay | 5 V (single supply) | 5 V |
| Rate ng Data | 5 Mbps (max) | — |
| Receiver Hysteresis | [DATA_NEEDED: receiver hysteresis] | — |
| Common-Mode Range | -7 V to +12 V | — |
| Driver Differential Output | [DATA_NEEDED: VOD min/max] | — |
| Hanay ng Temperature na Operasyon | -40 C to +85 C | [DATA_NEEDED: operating temperature range] |
| Packhaging | SOIC-8 (SO-8) / SO-8 | 8-pin SOIC |
| Uri ng Pagpapasok | Surface Mount | [DATA_NEEDED: surface-mount or through-hole mounting] |
| ESD Protection | [DATA_NEEDED: ESD HBM rating] | [DATA_NEEDED: ESD protection rating] |
| Tindminan RoHS | Compliant | — |
| REACH Status | Unaffected | — |
| Level ng MSL | 1 (Unlimited) | — |
| Compliance | ROHS3 Compliant | — |
| Enable Pins | Yes (DE driver enable, RE receiver enable, active-low/GPIO logic) | — |
| Product Type | — | Differential line transceiver |
| Supported Standards | — | EIA RS-485 and RS-422 |
| Driver Count | — | 1 |
| Receiver Count | — | 1 |
| Communication Mode | — | High-speed bidirectional |
| Bus Architecture | — | Multipoint balanced transmission line |
| Driver and Receiver Enable | — | Driver and receiver can be enabled |
| Signal Type | — | Differential balanced signaling |
| Logic Interface | — | [DATA_NEEDED: logic input and output voltage levels] |
| Maximum Data Rate | — | [DATA_NEEDED: maximum data rate] |
| Differential Driver Output | — | [DATA_NEEDED: differential output voltage and current] |
| Receiver Sensitivity | — | [DATA_NEEDED: receiver sensitivity] |
| Common-Mode Voltage Range | — | [DATA_NEEDED: common-mode voltage range] |
| Propagation Delay | — | [DATA_NEEDED: propagation delay] |
| RoHS | — | unknown |
| REACH | — | unknown |
| AEC-Q100 | — | unknown |