SP485E vs SN75176BDR Comparaison
Comparaison détaillée côte à côte de SP485E par MaxLinear et SN75176BDR par Texas Instruments. Comparez les spécifications clés, les paramètres électriques, le conditionnement, le statut de cycle de vie, les prix et la disponibilité pour déterminer le meilleur composant pour vos exigences de conception.
MaxLinear
SP485E - Enhanced Low Power Half-Duplex RS-485/RS-422 Transceiver | MaxLinear
SP485E ✓ ActifComparaison des spécifications
| Paramètre | SP485E | SN75176BDR |
|---|---|---|
| Marque | MaxLinear | Texas Instruments |
| Catégorie | Interface ICs | Interface ICs |
| Statut du cycle de vie | Actif | Actif |
| Fonction | Transceiver | — |
| Protocol | RS-485, RS-422 | — |
| Number of Drivers/Receivers | 1/1 | — |
| Duplex | Half-duplex | — |
| Débit de données | 2.5 Mbps (max, SP485E non-slew-limited) | — |
| Supply Voltage (VCC) | 4.75 V to 5.25 V | — |
| Receiver Input Sensitivity | ±200 mV | — |
| Receiver Input Impedance | 12 kΩ minimum, 15 kΩ typical | — |
| Common-Mode Range | −7 V to +12 V | — |
| ESD Protection (HBM) | ±15 kV | — |
| ESD Protection (IEC 61000-4-2 Air Discharge) | ±15 kV | — |
| Plage de température de fonctionnement | [DATA_NEEDED: operating temperature] | 0 °C to 70 °C |
| Boîtier | 8-pin NSOIC or PDIP | SOIC (D), 8 pins |
| Type de montage | Surface Mount (NSOIC) or Through-Hole (PDIP) | Surface mount |
| Process Technology | BiCMOS | — |
| Failsafe Receiver | Yes (open, shorted, idle bus) | — |
| Tri-State Enable Pins | Yes (DE, RE) | — |
| Statut RoHS | Compliant | [DATA_NEEDED: RoHS status] |
| Product Type | — | Differential bus transceiver |
| Tension d'alimentation | — | 5 V |
| Supported Standards | — | TIA/EIA-422-B and TIA/EIA-485-A |
| ITU Recommendations | — | V.11 and X.27 |
| Communication Mode | — | Bidirectional |
| Bus Architecture | — | Multipoint transmission |
| Transmission Line Type | — | Balanced transmission lines |
| Driver Output State | — | 3-state |
| Receiver Output State | — | 3-state |
| Nombre de broches | — | 8 pins |
| Manufacturer | — | Texas Instruments |
| REACH Status | — | [DATA_NEEDED: REACH status] |
| Automotive Qualification | — | [DATA_NEEDED: AEC-Q100 qualification] |
| Maximum Data Rate | — | [DATA_NEEDED: maximum data rate] |
| Input and Output Electrical Limits | — | [DATA_NEEDED: input and output electrical limits] |
| Propagation Delay | — | [DATA_NEEDED: propagation delay] |
| Courant de repos | — | [DATA_NEEDED: quiescent current] |