SP485E vs SN75176BDR तुलना
विस्तृत दोनों ओर की तुलना SP485E द्वारा MaxLinear और SN75176BDR द्वारा Texas Instruments. मुख्य विशेषताओं, इलेक्ट्रिकल पैरामीटर, पैकेजिंग, चक्र स्थिति, मूल्यांकन और उपलब्धता को तुलना करके अपनी डिजाइन की आवश्यकताओं के लिए सबसे अच्छा घटक निर्धारित करें。
MaxLinear
SP485E - Enhanced Low Power Half-Duplex RS-485/RS-422 Transceiver | MaxLinear
SP485E ✓ सक्रियविशेषता तुलना
| पैरामीटर | SP485E | SN75176BDR |
|---|---|---|
| ब्रांड | MaxLinear | Texas Instruments |
| श्रेणी | Interface ICs | Interface ICs |
| लाइफसाइकिल स्थिति | सक्रिय | सक्रिय |
| फ़ंक्शन | Transceiver | — |
| Protocol | RS-485, RS-422 | — |
| Number of Drivers/Receivers | 1/1 | — |
| Duplex | Half-duplex | — |
| डेटा दर | 2.5 Mbps (max, SP485E non-slew-limited) | — |
| Supply Voltage (VCC) | 4.75 V to 5.25 V | — |
| Receiver Input Sensitivity | ±200 mV | — |
| Receiver Input Impedance | 12 kΩ minimum, 15 kΩ typical | — |
| Common-Mode Range | −7 V to +12 V | — |
| ESD Protection (HBM) | ±15 kV | — |
| ESD Protection (IEC 61000-4-2 Air Discharge) | ±15 kV | — |
| ऑपरेटिंग तापमान रेंज | [DATA_NEEDED: operating temperature] | 0 °C to 70 °C |
| पैकेज | 8-pin NSOIC or PDIP | SOIC (D), 8 pins |
| माउंटिंग प्रकार | Surface Mount (NSOIC) or Through-Hole (PDIP) | Surface mount |
| Process Technology | BiCMOS | — |
| Failsafe Receiver | Yes (open, shorted, idle bus) | — |
| Tri-State Enable Pins | Yes (DE, RE) | — |
| RoHS स्थिति | Compliant | [DATA_NEEDED: RoHS status] |
| Product Type | — | Differential bus transceiver |
| सप्लाई वोल्टेज | — | 5 V |
| Supported Standards | — | TIA/EIA-422-B and TIA/EIA-485-A |
| ITU Recommendations | — | V.11 and X.27 |
| Communication Mode | — | Bidirectional |
| Bus Architecture | — | Multipoint transmission |
| Transmission Line Type | — | Balanced transmission lines |
| Driver Output State | — | 3-state |
| Receiver Output State | — | 3-state |
| पिन काउंट | — | 8 pins |
| Manufacturer | — | Texas Instruments |
| REACH Status | — | [DATA_NEEDED: REACH status] |
| Automotive Qualification | — | [DATA_NEEDED: AEC-Q100 qualification] |
| Maximum Data Rate | — | [DATA_NEEDED: maximum data rate] |
| Input and Output Electrical Limits | — | [DATA_NEEDED: input and output electrical limits] |
| Propagation Delay | — | [DATA_NEEDED: propagation delay] |
| क्वाइसेंट करंट | — | [DATA_NEEDED: quiescent current] |