SN75176BDR vs SP485E Perbandingan
Perbandingan bersamaan detil SN75176BDR dari Texas Instruments dan SP485E dari MaxLinear. Bandingkan spesifikasi penting, parameter listrik, pengemasan, status cycle, harga, dan ketersediaan untuk menentukan komponen terbaik untuk kebutuhan desain Anda.
MaxLinear
SP485E - Enhanced Low Power Half-Duplex RS-485/RS-422 Transceiver | MaxLinear
SP485E ✓ AktifPerbandingan Spesifikasi
| Parameter Umum | SN75176BDR | SP485E |
|---|---|---|
| Merek | Texas Instruments | MaxLinear |
| Kategori | Interface ICs | Interface ICs |
| Status Lingkungan Hidup | Aktif | Aktif |
| Product Type | Differential bus transceiver | — |
| Tegangan Pemuat | 5 V | — |
| Supported Standards | TIA/EIA-422-B and TIA/EIA-485-A | — |
| ITU Recommendations | V.11 and X.27 | — |
| Communication Mode | Bidirectional | — |
| Bus Architecture | Multipoint transmission | — |
| Transmission Line Type | Balanced transmission lines | — |
| Driver Output State | 3-state | — |
| Receiver Output State | 3-state | — |
| Rentang Suhu Kerja | 0 °C to 70 °C | [DATA_NEEDED: operating temperature] |
| Paket | SOIC (D), 8 pins | 8-pin NSOIC or PDIP |
| Tipe Mounting | Surface mount | Surface Mount (NSOIC) or Through-Hole (PDIP) |
| Jumlah Pin | 8 pins | — |
| Manufacturer | Texas Instruments | — |
| Status RoHS | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| Automotive Qualification | [DATA_NEEDED: AEC-Q100 qualification] | — |
| Maximum Data Rate | [DATA_NEEDED: maximum data rate] | — |
| Input and Output Electrical Limits | [DATA_NEEDED: input and output electrical limits] | — |
| Propagation Delay | [DATA_NEEDED: propagation delay] | — |
| Arus Memerintah | [DATA_NEEDED: quiescent current] | — |
| Fungsi | — | Transceiver |
| Protocol | — | RS-485, RS-422 |
| Number of Drivers/Receivers | — | 1/1 |
| Duplex | — | Half-duplex |
| Laju Data | — | 2.5 Mbps (max, SP485E non-slew-limited) |
| Supply Voltage (VCC) | — | 4.75 V to 5.25 V |
| Receiver Input Sensitivity | — | ±200 mV |
| Receiver Input Impedance | — | 12 kΩ minimum, 15 kΩ typical |
| Common-Mode Range | — | −7 V to +12 V |
| ESD Protection (HBM) | — | ±15 kV |
| ESD Protection (IEC 61000-4-2 Air Discharge) | — | ±15 kV |
| Process Technology | — | BiCMOS |
| Failsafe Receiver | — | Yes (open, shorted, idle bus) |
| Tri-State Enable Pins | — | Yes (DE, RE) |