SN75176BDR vs SP485E Pengandingan
Pengandingan Sisi Kiri Sisi Kanan Terperinci SN75176BDR disebabkan oleh Texas Instruments dan SP485E disebabkan oleh MaxLinear. Bandingkan spesifikasi utama, parameter elektrik, pakej, status kehidupan, harga, dan keupayaan untuk menentukan komponen terbaik untuk keperluan disenjaya anda.
MaxLinear
SP485E - Enhanced Low Power Half-Duplex RS-485/RS-422 Transceiver | MaxLinear
SP485E ✓ AktifPengandingan Spesifikasi
| Parametr | SN75176BDR | SP485E |
|---|---|---|
| Merek | Texas Instruments | MaxLinear |
| Kategori | Interface ICs | Interface ICs |
| Status Lingkungan Hidup | Aktif | Aktif |
| Product Type | Differential bus transceiver | — |
| Tegangan Pemberi Arus | 5 V | — |
| Supported Standards | TIA/EIA-422-B and TIA/EIA-485-A | — |
| ITU Recommendations | V.11 and X.27 | — |
| Communication Mode | Bidirectional | — |
| Bus Architecture | Multipoint transmission | — |
| Transmission Line Type | Balanced transmission lines | — |
| Driver Output State | 3-state | — |
| Receiver Output State | 3-state | — |
| Gambaran Suhu Operasi | 0 °C to 70 °C | [DATA_NEEDED: operating temperature] |
| Kemasan | SOIC (D), 8 pins | 8-pin NSOIC or PDIP |
| Jenis Pemasangan | Surface mount | Surface Mount (NSOIC) or Through-Hole (PDIP) |
| Kiraan Pin | 8 pins | — |
| Manufacturer | Texas Instruments | — |
| Status RoHS | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| Automotive Qualification | [DATA_NEEDED: AEC-Q100 qualification] | — |
| Maximum Data Rate | [DATA_NEEDED: maximum data rate] | — |
| Input and Output Electrical Limits | [DATA_NEEDED: input and output electrical limits] | — |
| Propagation Delay | [DATA_NEEDED: propagation delay] | — |
| Arus Dalam Tentera | [DATA_NEEDED: quiescent current] | — |
| Fungsi | — | Transceiver |
| Protocol | — | RS-485, RS-422 |
| Number of Drivers/Receivers | — | 1/1 |
| Duplex | — | Half-duplex |
| Kadar Data | — | 2.5 Mbps (max, SP485E non-slew-limited) |
| Supply Voltage (VCC) | — | 4.75 V to 5.25 V |
| Receiver Input Sensitivity | — | ±200 mV |
| Receiver Input Impedance | — | 12 kΩ minimum, 15 kΩ typical |
| Common-Mode Range | — | −7 V to +12 V |
| ESD Protection (HBM) | — | ±15 kV |
| ESD Protection (IEC 61000-4-2 Air Discharge) | — | ±15 kV |
| Process Technology | — | BiCMOS |
| Failsafe Receiver | — | Yes (open, shorted, idle bus) |
| Tri-State Enable Pins | — | Yes (DE, RE) |