SN75176BDR vs SP485E Karşılaştırma
Ayrıntılı yan yana karşılaştırma SN75176BDR tarafından Texas Instruments ve SP485E tarafından MaxLinearAnahtar özellikleri, elektriksel parametreleri, ambalajı, yaşam döngüsü durumu, fiyatlandırma ve mevcudiyeti karşılaştırarak tasarım gereksinimleriniz için en iyi bileşeni belirleyin.
MaxLinear
SP485E - Enhanced Low Power Half-Duplex RS-485/RS-422 Transceiver | MaxLinear
SP485E ✓ AktifÖzellik Karşılaştırması
| Parametre | SN75176BDR | SP485E |
|---|---|---|
| Marka | Texas Instruments | MaxLinear |
| Kategori | Interface ICs | Interface ICs |
| Yaşam Döngüsü Durumu | Aktif | Aktif |
| Product Type | Differential bus transceiver | — |
| Besleme Gerilimi | 5 V | — |
| Supported Standards | TIA/EIA-422-B and TIA/EIA-485-A | — |
| ITU Recommendations | V.11 and X.27 | — |
| Communication Mode | Bidirectional | — |
| Bus Architecture | Multipoint transmission | — |
| Transmission Line Type | Balanced transmission lines | — |
| Driver Output State | 3-state | — |
| Receiver Output State | 3-state | — |
| İşletim Sıcaklığı Aralığı | 0 °C to 70 °C | [DATA_NEEDED: operating temperature] |
| Paket | SOIC (D), 8 pins | 8-pin NSOIC or PDIP |
| Montaj Türü | Surface mount | Surface Mount (NSOIC) or Through-Hole (PDIP) |
| Pin Sayısı | 8 pins | — |
| Manufacturer | Texas Instruments | — |
| RoHS Durumu | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| Automotive Qualification | [DATA_NEEDED: AEC-Q100 qualification] | — |
| Maximum Data Rate | [DATA_NEEDED: maximum data rate] | — |
| Input and Output Electrical Limits | [DATA_NEEDED: input and output electrical limits] | — |
| Propagation Delay | [DATA_NEEDED: propagation delay] | — |
| Durağan Akım | [DATA_NEEDED: quiescent current] | — |
| Fonksiyon | — | Transceiver |
| Protocol | — | RS-485, RS-422 |
| Number of Drivers/Receivers | — | 1/1 |
| Duplex | — | Half-duplex |
| Veri Hızı | — | 2.5 Mbps (max, SP485E non-slew-limited) |
| Supply Voltage (VCC) | — | 4.75 V to 5.25 V |
| Receiver Input Sensitivity | — | ±200 mV |
| Receiver Input Impedance | — | 12 kΩ minimum, 15 kΩ typical |
| Common-Mode Range | — | −7 V to +12 V |
| ESD Protection (HBM) | — | ±15 kV |
| ESD Protection (IEC 61000-4-2 Air Discharge) | — | ±15 kV |
| Process Technology | — | BiCMOS |
| Failsafe Receiver | — | Yes (open, shorted, idle bus) |
| Tri-State Enable Pins | — | Yes (DE, RE) |