MAX485EESA+T vs SN65HVD05D Pengandingan
Pengandingan Sisi Kiri Sisi Kanan Terperinci MAX485EESA+T disebabkan oleh Analog Devices dan SN65HVD05D disebabkan oleh Texas Instruments. Bandingkan spesifikasi utama, parameter elektrik, pakej, status kehidupan, harga, dan keupayaan untuk menentukan komponen terbaik untuk keperluan disenjaya anda.
Texas Instruments
SN65HVD05D - High-Output RS-485 Transceiver | Texas Instruments
SN65HVD05D ✓ AktifPengandingan Spesifikasi
| Parametr | MAX485EESA+T | SN65HVD05D |
|---|---|---|
| Merek | Analog Devices | Texas Instruments |
| Kategori | Interface ICs | Interface ICs |
| Status Lingkungan Hidup | Aktif | Aktif |
| Product Type | Half-duplex RS-485/RS-422 transceiver | Half-duplex RS-422/RS-485 transceiver |
| Supply Voltage Range | 4.75 V to 5.25 V | 4.5 V to 5.5 V |
| Nominal Supply Voltage | 5 V | — |
| Maximum Data Rate | 2.5 Mbps | — |
| Driver Output Type | Slew-rate-limited differential driver | — |
| Receiver Output Type | Differential logic-level receiver | — |
| ESD Protection | ±15 kV | — |
| Communication Mode | Half-duplex | Half-duplex |
| Supported Standards | RS-485 and RS-422 | — |
| Kemasan | 8-pin NSOIC/SOIC | 8-pin SOIC (D) |
| Jenis Pemasangan | Surface mount | Surface mount |
| Gambaran Suhu Operasi | -40 °C to +85 °C | [DATA_NEEDED: operating temperature range] |
| Driver and Receiver Count | 1 driver and 1 receiver | 1 differential driver and 1 differential receiver |
| Power Classification | Low-power transceiver | — |
| Status RoHS | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS status] |
| REACH Status | [DATA_NEEDED: REACH status] | [DATA_NEEDED: REACH status] |
| MSL | [DATA_NEEDED: moisture sensitivity level] | — |
| Maximum Bus Length | [DATA_NEEDED: maximum bus length] | — |
| Minimum Differential Output Voltage | — | 2.5 V into a 54-ohm load |
| Driver Output State | — | 3-state |
| Receiver Failsafe Behavior | — | Open-circuit, short-circuit, and idle-bus failsafe |
| Unit Load Option | — | 1/8 unit load |
| Maximum Node Count | — | Up to 256 nodes on the bus |
| Bus-Pin ESD Protection | — | Exceeds 16 kV HBM |
| Driver Output Slew Rate | — | Controlled |
| Standards Compatibility | — | ANSI TIA/EIA-485-A and ISO 8482E |
| AEC-Q100 Qualification | — | [DATA_NEEDED: AEC-Q100 qualification status] |