INA2126UG4 vs INA2126U 比較
詳細並排比較 INA2126UG4 由 Texas Instruments 與 INA2126U 由 Texas Instruments. 比較關鍵規格、電氣參數、封裝、生命週期狀態、價格與供貨情況,以找出最符合您設計需求的元件。
Texas Instruments
INA2126U - 36V Dual Micropower Instrumentation Amplifier | Texas Instruments
INA2126U ✓ 啟用中規格比較
| 參數 | INA2126UG4 | INA2126U |
|---|---|---|
| 品牌 | Texas Instruments | Texas Instruments |
| 類別 | Amplifier ICs | Amplifier ICs |
| 生命週期狀態 | 啟用中 | 啟用中 |
| Device Type | Dual precision instrumentation amplifier | — |
| Channel Count | 2 channels | — |
| Maximum Supply Voltage | 36 V | — |
| Supply Voltage Range | ±1.35 V to ±18 V | — |
| Single-Supply Minimum | 2.7 V | — |
| 靜態電流 | 175 µA per channel | — |
| Offset Voltage | 250 µV | — |
| Architecture | Two-op-amp instrumentation-amplifier design | — |
| Input Type | Differential | — |
| Signal Type | Low-level differential-signal acquisition | — |
| 封裝 | 16-pin SOIC, 3.90 mm width | 16-pin SOIC |
| 安裝類型 | Surface mount | Surface mount |
| 工作溫度範圍 | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature range] |
| Gain Settings | [DATA_NEEDED: available gain settings] | — |
| Input Common-Mode Range | [DATA_NEEDED: input common-mode range] | — |
| 輸出電壓範圍 | [DATA_NEEDED: output voltage range] | — |
| Gain Error | [DATA_NEEDED: gain error] | — |
| Noise Performance | [DATA_NEEDED: input noise density] | — |
| Bandwidth | [DATA_NEEDED: signal bandwidth] | — |
| Slew Rate | [DATA_NEEDED: slew rate] | [DATA_NEEDED: slew rate] |
| RoHS 狀態 | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS status] |
| REACH Status | [DATA_NEEDED: REACH status] | [DATA_NEEDED: REACH status] |
| Amplifier Type | — | Dual precision instrumentation amplifier |
| Number of Channels | — | 2 channels |
| Maximum Total Supply Voltage | — | 36 V |
| Operating Supply Range | — | ±1.35 V to ±18 V |
| Minimum Total Supply Voltage | — | 2.7 V |
| Quiescent Current per Channel | — | 175 µA |
| Maximum Input Offset Voltage | — | 250 µV |
| Minimum Voltage Gain | — | 5 V/V |
| Maximum Voltage Gain | — | 10000 V/V |
| Typical Gain-Bandwidth Product | — | 200 kHz |
| Typical Input Noise Density at 1 kHz | — | 0.4 nV/√Hz |
| Internal Architecture | — | Two-op-amp instrumentation amplifier |
| Input Bias Current | — | [DATA_NEEDED: input bias current] |
| Common-Mode Rejection Ratio | — | [DATA_NEEDED: common-mode rejection ratio] |
| AEC-Q100 Qualification | — | [DATA_NEEDED: AEC-Q100 qualification] |