SN65HVD53D vs SN65HVD51D Vergleich
Detaillierter Direktvergleich von SN65HVD53D von Texas Instruments und SN65HVD51D von Texas Instruments. Vergleichen Sie die wichtigsten Spezifikationen, elektrischen Parameter, Gehäuse, Lebenszyklusstatus, Preise und Verfügbarkeit, um das beste Bauteil für Ihre Designanforderungen zu ermitteln.
Texas Instruments
SN65HVD53D - High-Output Full-Duplex RS-485 Transceiver | Texas Instruments
SN65HVD53D ✓ AktivTexas Instruments
SN65HVD51D - 5Mbps Full-Duplex RS-485 Transceiver | Texas Instruments
SN65HVD51D ✓ AktivSpezifikationsvergleich
| Parameter | SN65HVD53D | SN65HVD51D |
|---|---|---|
| Marke | Texas Instruments | Texas Instruments |
| Kategorie | Interface ICs | Interface ICs |
| Lebenszyklusstatus | Aktiv | Aktiv |
| Device Type | Full-duplex RS-485 / RS-422 transceiver with enables | — |
| Number of Drivers / Receivers | 1 / 1 | — |
| Driver Enable Polarity | Active-high | — |
| Receiver Enable Polarity | Active-low | — |
| Unit Load Option | 1/8 unit-load option available (up to 256 nodes on the bus) | — |
| Maximum Nodes on Bus | 256 nodes | — |
| Bus Pin ESD Protection | Exceeds 15 kV HBM | — |
| Driver Output Transition Time Options | 1 Mbps, 5 Mbps and 25 Mbps signaling rates | — |
| Standby Current | 1 uA (both driver and receiver disabled) | Less than 1 µA |
| Receiver Output | Glitch-free | — |
| Standards Supported | RS-485, RS-422 | — |
| Supply Voltage Range | [DATA_NEEDED: supply voltage range] | 4.5 V to 5.5 V |
| Maximum Data Rate (this device) | [DATA_NEEDED: maximum data rate for SN65HVD53D] | — |
| Driver Output Current | [DATA_NEEDED: high-output driver current] | — |
| Receiver Sensitivity | [DATA_NEEDED: receiver input sensitivity] | — |
| Betriebstemperaturbereich | -40 C to +85 C | -40 °C to 85 °C |
| Gehäuse | SOIC (D), 14 pins, 3.90 mm width, 0.154 inch pitch | 8-pin SOIC (D) |
| Montageart | Surface mount | Surface mount |
| RoHS-Status | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS compliance status] |
| Product Type | — | RS-422/RS-485 full-duplex transceiver |
| Driver Count | — | 1 driver |
| Receiver Count | — | 1 receiver |
| Maximum Signaling Rate | — | 5 Mbps |
| Interface Standards | — | RS-422 and RS-485 |
| Duplex Mode | — | Full-duplex |
| Receiver Unit Load | — | 1/8 unit load |
| Maximum Bus Nodes | — | Up to 256 nodes |
| Bus-Pin ESD Protection | — | Exceeds 15 kV HBM |
| Available Driver Transition Rates | — | 1 Mbps, 5 Mbps, and 25 Mbps |
| Enable Architecture | — | Fully enabled; no external enable pins |
| REACH Status | — | [DATA_NEEDED: REACH compliance status] |