SN65HVD53D vs SN65HVD51D Pengandingan
Pengandingan Sisi Kiri Sisi Kanan Terperinci SN65HVD53D disebabkan oleh Texas Instruments dan SN65HVD51D disebabkan oleh Texas Instruments. Bandingkan spesifikasi utama, parameter elektrik, pakej, status kehidupan, harga, dan keupayaan untuk menentukan komponen terbaik untuk keperluan disenjaya anda.
Texas Instruments
SN65HVD53D - High-Output Full-Duplex RS-485 Transceiver | Texas Instruments
SN65HVD53D ✓ AktifTexas Instruments
SN65HVD51D - 5Mbps Full-Duplex RS-485 Transceiver | Texas Instruments
SN65HVD51D ✓ AktifPengandingan Spesifikasi
| Parametr | SN65HVD53D | SN65HVD51D |
|---|---|---|
| Merek | Texas Instruments | Texas Instruments |
| Kategori | Interface ICs | Interface ICs |
| Status Lingkungan Hidup | Aktif | Aktif |
| Device Type | Full-duplex RS-485 / RS-422 transceiver with enables | — |
| Number of Drivers / Receivers | 1 / 1 | — |
| Driver Enable Polarity | Active-high | — |
| Receiver Enable Polarity | Active-low | — |
| Unit Load Option | 1/8 unit-load option available (up to 256 nodes on the bus) | — |
| Maximum Nodes on Bus | 256 nodes | — |
| Bus Pin ESD Protection | Exceeds 15 kV HBM | — |
| Driver Output Transition Time Options | 1 Mbps, 5 Mbps and 25 Mbps signaling rates | — |
| Standby Current | 1 uA (both driver and receiver disabled) | Less than 1 µA |
| Receiver Output | Glitch-free | — |
| Standards Supported | RS-485, RS-422 | — |
| Supply Voltage Range | [DATA_NEEDED: supply voltage range] | 4.5 V to 5.5 V |
| Maximum Data Rate (this device) | [DATA_NEEDED: maximum data rate for SN65HVD53D] | — |
| Driver Output Current | [DATA_NEEDED: high-output driver current] | — |
| Receiver Sensitivity | [DATA_NEEDED: receiver input sensitivity] | — |
| Gambaran Suhu Operasi | -40 C to +85 C | -40 °C to 85 °C |
| Kemasan | SOIC (D), 14 pins, 3.90 mm width, 0.154 inch pitch | 8-pin SOIC (D) |
| Jenis Pemasangan | Surface mount | Surface mount |
| Status RoHS | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS compliance status] |
| Product Type | — | RS-422/RS-485 full-duplex transceiver |
| Driver Count | — | 1 driver |
| Receiver Count | — | 1 receiver |
| Maximum Signaling Rate | — | 5 Mbps |
| Interface Standards | — | RS-422 and RS-485 |
| Duplex Mode | — | Full-duplex |
| Receiver Unit Load | — | 1/8 unit load |
| Maximum Bus Nodes | — | Up to 256 nodes |
| Bus-Pin ESD Protection | — | Exceeds 15 kV HBM |
| Available Driver Transition Rates | — | 1 Mbps, 5 Mbps, and 25 Mbps |
| Enable Architecture | — | Fully enabled; no external enable pins |
| REACH Status | — | [DATA_NEEDED: REACH compliance status] |