EPC2TC32UCF48 vs EPC2TC32U 비교
다음의 상세 나란히 비교: EPC2TC32UCF48 제조: Intel 및 EPC2TC32U 제조: Altera. 주요 사양, 전기적 파라미터, 패키징, 수명 주기 상태, 가격 및 재고를 비교하여 설계 요구 사항에 가장 적합한 부품을 결정하십시오.
사양 비교
| 파라미터 | EPC2TC32UCF48 | EPC2TC32U |
|---|---|---|
| 브랜드 | Intel | Altera |
| 카테고리 | Memory ICs | FPGA & CPLD |
| 수명 주기 상태 | NRND | NRND |
| 재고 상태 | In Stock | In Stock |
| 단가 (USD) | $10.85 | $5.85 |
| 메모리 유형 | Non-volatile configuration PROM (CMOS Flash-based) | — |
| Memory Density | 1.6 Mbit (1.6 Mb / 32 Mbit raw) | — |
| Memory Configuration | Serial configuration bitstream storage | — |
| Supply Voltage (VCC) | 3.0 V to 3.6 V (3.3 V typical) | — |
| Supply Voltage (VCCIO) | 1.8 V / 2.5 V / 3.3 V (bank-level) | — |
| Output Drive Current (VCCIO) | [DATA_NEEDED: IOH/IOL at 3.3 V VCCIO] | — |
| Programming Interface | IEEE Std. 1149.1 JTAG (in-system programmable) | — |
| Configuration Interface | Altera serial PROM interface (DCLK, DATA, nCONFIG, nSTATUS, CONF_DONE) | Altera Passive Serial (DCLK / DATA0 / nCONFIG / nSTATUS / CONF_DONE) |
| Supported Configuration Modes | FPP, AS, PS, JTAG (mode dependent on target FPGA MSEL pins) | — |
| Daisy Chain Support | Yes (multi-device cascade for >16 Mbit FPGAs) | — |
| Maximum Cascaded Capacity | Up to 16 Mbit total across chain | — |
| 동작 온도 | 0C to +70C (commercial) | -40 C to +85 C |
| 패키지 | 48-pin TQFP (7x7 mm) | 32-pin QFP (CAF48, lead-free) |
| 실장 유형 | Surface Mount | Surface Mount |
| MSL 레벨 | [DATA_NEEDED: MSL rating] | [DATA_NEEDED: MSL level] |
| RoHS 상태 | [DATA_NEEDED: confirm RoHS compliance] | Compliant (lead-free / RoHS per distributor data) |
| Lead Free | [DATA_NEEDED: confirm lead-free] | — |
| 기능 | — | Serial Configuration Device for SRAM-based LUT FPGAs |
| 메모리 크기 | — | 1.6 Mbit |
| JTAG Support | — | Yes (IEEE 1149.1 boundary-scan, ISP) |
| 공급 전압 | — | 3.0 V to 3.6 V or 4.75 V to 5.25 V |
| Lead-Free Finish | — | Yes (U suffix) |
| Supported FPGA Families | — | Altera Stratix, Cyclone, APEX, ACEX, Mercury, Excalibur |
| Configuration Mode | — | Passive Serial (PS), JTAG |
| Configuration Time | — | [DATA_NEEDED: typical configuration time] |
| Programming Cycles | — | [DATA_NEEDED: minimum program/erase cycles] |
| Data Retention | — | [DATA_NEEDED: minimum data retention years] |