SN65HVD11D vs SN65HVD77D So sánh
So sánh chi tiết song song của SN65HVD11D bằng Texas Instruments và SN65HVD77D bằng Texas Instruments. So sánh các thông số quan trọng, thông số điện tử, gói gọn, trạng thái vòng đời, giá cả và khả năng cung cấp để xác định linh kiện tốt nhất cho yêu cầu thiết kế của bạn.
Texas Instruments
SN65HVD77D - 3.3V 50Mbps Full-Duplex RS-485 | Texas Instruments
SN65HVD77D ✓ Hoạt độngSo sánh thông số kỹ thuật
| Tham số | SN65HVD11D | SN65HVD77D |
|---|---|---|
| Thương hiệu | Texas Instruments | Texas Instruments |
| Danh mục | Interface ICs | Interface ICs |
| Trạng thái vòng đời | Hoạt động | Hoạt động |
| Product Type | Differential transceiver | Full-duplex RS-485 transceiver |
| Supported Interfaces | RS-485 and RS-422 | — |
| Điện áp cung cấp | 3.3 V | — |
| Driver Output State | Three-state | — |
| Receiver Architecture | Differential input | — |
| Unit Load | 1/8 unit load | — |
| Maximum Bus Nodes | Up to 256 nodes | — |
| Bus-Pin ESD Protection | Exceeds 16 kV HBM | — |
| Standards | ANSI TIA/EIA-485-A and ISO 8482:1993 | — |
| Nhiệt độ hoạt động | -40 °C to +85 °C | — |
| Hộp | 8-pin SOIC (D) | 8-pin SOIC (D) |
| Số chân | 8 pins | — |
| Kiểu lắp đặt | Surface mount | Surface mount |
| Output Current | [DATA_NEEDED: output current] | — |
| Tốc độ dữ liệu | [DATA_NEEDED: maximum data rate] | — |
| Differential Output Voltage | [DATA_NEEDED: differential output voltage] | — |
| Receiver Differential Threshold | [DATA_NEEDED: receiver differential threshold] | — |
| Điện áp cung cấp | [DATA_NEEDED: operating supply current] | — |
| Trạng thái RoHS | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| Supply Voltage Range | — | 3.0 V to 3.6 V |
| Nominal Supply Voltage | — | 3.3 V |
| Maximum Data Rate | — | 50 Mbps |
| Number of Drivers | — | 1 |
| Number of Receivers | — | 1 |
| Duplex Mode | — | Full duplex |
| Supported Standards | — | RS-485 and RS-422 |
| ESD Protection | — | ±12 kV IEC |
| Khoảng nhiệt độ hoạt động | — | -40°C to 125°C |
| Package Width | — | 3.90 mm |
| External Enable Controls | — | None |
| Driver Output Type | — | Differential |
| Receiver Output Type | — | Single-ended logic output |
| Low-Power Standby Current | — | Less than 5 µA when driver and receiver are disabled |
| Termination Requirement | — | External termination required |