SN65HVD08D vs SN65HVD77D Perbandingan
Perbandingan bersamaan detil SN65HVD08D dari Texas Instruments dan SN65HVD77D dari Texas Instruments. Bandingkan spesifikasi penting, parameter listrik, pengemasan, status cycle, harga, dan ketersediaan untuk menentukan komponen terbaik untuk kebutuhan desain Anda.
Texas Instruments
SN65HVD08D - 3.3/5V 10Mbps RS-485 Transceiver | Texas Instruments
SN65HVD08D ✓ AktifTexas Instruments
SN65HVD77D - 3.3V 50Mbps Full-Duplex RS-485 | Texas Instruments
SN65HVD77D ✓ AktifPerbandingan Spesifikasi
| Parameter Umum | SN65HVD08D | SN65HVD77D |
|---|---|---|
| Merek | Texas Instruments | Texas Instruments |
| Kategori | Interface ICs | Interface ICs |
| Status Lingkungan Hidup | Aktif | Aktif |
| Product Type | Half-duplex RS-485 transceiver | Full-duplex RS-485 transceiver |
| Tegangan Pemuat | 3.3/5 V | — |
| Maximum Supply Voltage | 5.5 V | — |
| Maximum Data Rate | 10 Mbps | 50 Mbps |
| Quiescent Power Consumption | Less than 90 mW | — |
| Receiver Unit Load | 1/8 unit load | — |
| Maximum Bus Nodes | Up to 256 nodes | — |
| Bus-Pin ESD Protection | Exceeds 16 kV HBM | — |
| Driver Output Type | Three-state differential line driver | Differential |
| Receiver Type | Differential line receiver | — |
| Failsafe Receiver Behavior | Open-circuit, short-circuit, and idle-bus failsafe | — |
| Standards Compatibility | ANSI TIA/EIA-485-A and ISO-8482E | — |
| Cable-Powered Operation | 5-V power bus with up to 2 V line-voltage drop | — |
| Paket | 8-pin SOIC | 8-pin SOIC (D) |
| Tipe Mounting | Surface mount | Surface mount |
| Rentang Suhu Kerja | [DATA_NEEDED: operating temperature range] | -40°C to 125°C |
| Status RoHS | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| Supply Voltage Range | — | 3.0 V to 3.6 V |
| Nominal Supply Voltage | — | 3.3 V |
| Number of Drivers | — | 1 |
| Number of Receivers | — | 1 |
| Duplex Mode | — | Full duplex |
| Supported Standards | — | RS-485 and RS-422 |
| ESD Protection | — | ±12 kV IEC |
| Package Width | — | 3.90 mm |
| External Enable Controls | — | None |
| Receiver Output Type | — | Single-ended logic output |
| Low-Power Standby Current | — | Less than 5 µA when driver and receiver are disabled |
| Termination Requirement | — | External termination required |