SN65HVD08D vs SN65HVD77D So sánh
So sánh chi tiết song song của SN65HVD08D bằng Texas Instruments và SN65HVD77D bằng Texas Instruments. So sánh các thông số quan trọng, thông số điện tử, gói gọn, trạng thái vòng đời, giá cả và khả năng cung cấp để xác định linh kiện tốt nhất cho yêu cầu thiết kế của bạn.
Texas Instruments
SN65HVD08D - 3.3/5V 10Mbps RS-485 Transceiver | Texas Instruments
SN65HVD08D ✓ Hoạt độngTexas Instruments
SN65HVD77D - 3.3V 50Mbps Full-Duplex RS-485 | Texas Instruments
SN65HVD77D ✓ Hoạt độngSo sánh thông số kỹ thuật
| Tham số | SN65HVD08D | SN65HVD77D |
|---|---|---|
| Thương hiệu | Texas Instruments | Texas Instruments |
| Danh mục | Interface ICs | Interface ICs |
| Trạng thái vòng đời | Hoạt động | Hoạt động |
| Product Type | Half-duplex RS-485 transceiver | Full-duplex RS-485 transceiver |
| Điện áp cung cấp | 3.3/5 V | — |
| Maximum Supply Voltage | 5.5 V | — |
| Maximum Data Rate | 10 Mbps | 50 Mbps |
| Quiescent Power Consumption | Less than 90 mW | — |
| Receiver Unit Load | 1/8 unit load | — |
| Maximum Bus Nodes | Up to 256 nodes | — |
| Bus-Pin ESD Protection | Exceeds 16 kV HBM | — |
| Driver Output Type | Three-state differential line driver | Differential |
| Receiver Type | Differential line receiver | — |
| Failsafe Receiver Behavior | Open-circuit, short-circuit, and idle-bus failsafe | — |
| Standards Compatibility | ANSI TIA/EIA-485-A and ISO-8482E | — |
| Cable-Powered Operation | 5-V power bus with up to 2 V line-voltage drop | — |
| Hộp | 8-pin SOIC | 8-pin SOIC (D) |
| Kiểu lắp đặt | Surface mount | Surface mount |
| Khoảng nhiệt độ hoạt động | [DATA_NEEDED: operating temperature range] | -40°C to 125°C |
| Trạng thái RoHS | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| Supply Voltage Range | — | 3.0 V to 3.6 V |
| Nominal Supply Voltage | — | 3.3 V |
| Number of Drivers | — | 1 |
| Number of Receivers | — | 1 |
| Duplex Mode | — | Full duplex |
| Supported Standards | — | RS-485 and RS-422 |
| ESD Protection | — | ±12 kV IEC |
| Package Width | — | 3.90 mm |
| External Enable Controls | — | None |
| Receiver Output Type | — | Single-ended logic output |
| Low-Power Standby Current | — | Less than 5 µA when driver and receiver are disabled |
| Termination Requirement | — | External termination required |