SN65HVD08D vs SN65HVD77D Ikinahambing
Detalyadong pagkakahiwalay na pagkakahambing ng SN65HVD08D sa pamamagitan ng Texas Instruments at SN65HVD77D sa pamamagitan ng Texas Instruments. Ikinahambing ang mga pangunahing paglalarawan, mga tama ng elektriko, paakay, kalagayan ng buhay, presyo, at pagkakaroon upang makita ang pinakamahusay na komponente para sa iyong mga kinakailangang pang disenyo.
Texas Instruments
SN65HVD08D - 3.3/5V 10Mbps RS-485 Transceiver | Texas Instruments
SN65HVD08D ✓ NakahandaTexas Instruments
SN65HVD77D - 3.3V 50Mbps Full-Duplex RS-485 | Texas Instruments
SN65HVD77D ✓ NakahandaPagsanggunian na paghahambing
| Parametro | SN65HVD08D | SN65HVD77D |
|---|---|---|
| Brand | Texas Instruments | Texas Instruments |
| Kategorya | Interface ICs | Interface ICs |
| Katayuan ng Lifecycle | Aktibo | Aktibo |
| Product Type | Half-duplex RS-485 transceiver | Full-duplex RS-485 transceiver |
| Volte ng Pagbibigay | 3.3/5 V | — |
| Maximum Supply Voltage | 5.5 V | — |
| Maximum Data Rate | 10 Mbps | 50 Mbps |
| Quiescent Power Consumption | Less than 90 mW | — |
| Receiver Unit Load | 1/8 unit load | — |
| Maximum Bus Nodes | Up to 256 nodes | — |
| Bus-Pin ESD Protection | Exceeds 16 kV HBM | — |
| Driver Output Type | Three-state differential line driver | Differential |
| Receiver Type | Differential line receiver | — |
| Failsafe Receiver Behavior | Open-circuit, short-circuit, and idle-bus failsafe | — |
| Standards Compatibility | ANSI TIA/EIA-485-A and ISO-8482E | — |
| Cable-Powered Operation | 5-V power bus with up to 2 V line-voltage drop | — |
| Packhaging | 8-pin SOIC | 8-pin SOIC (D) |
| Uri ng Pagpapasok | Surface mount | Surface mount |
| Hanay ng Temperature na Operasyon | [DATA_NEEDED: operating temperature range] | -40°C to 125°C |
| Tindminan RoHS | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| Supply Voltage Range | — | 3.0 V to 3.6 V |
| Nominal Supply Voltage | — | 3.3 V |
| Number of Drivers | — | 1 |
| Number of Receivers | — | 1 |
| Duplex Mode | — | Full duplex |
| Supported Standards | — | RS-485 and RS-422 |
| ESD Protection | — | ±12 kV IEC |
| Package Width | — | 3.90 mm |
| External Enable Controls | — | None |
| Receiver Output Type | — | Single-ended logic output |
| Low-Power Standby Current | — | Less than 5 µA when driver and receiver are disabled |
| Termination Requirement | — | External termination required |