SN65HVD08D vs SN65HVD77D Pengandingan
Pengandingan Sisi Kiri Sisi Kanan Terperinci SN65HVD08D disebabkan oleh Texas Instruments dan SN65HVD77D disebabkan oleh Texas Instruments. Bandingkan spesifikasi utama, parameter elektrik, pakej, status kehidupan, harga, dan keupayaan untuk menentukan komponen terbaik untuk keperluan disenjaya anda.
Texas Instruments
SN65HVD08D - 3.3/5V 10Mbps RS-485 Transceiver | Texas Instruments
SN65HVD08D ✓ AktifTexas Instruments
SN65HVD77D - 3.3V 50Mbps Full-Duplex RS-485 | Texas Instruments
SN65HVD77D ✓ AktifPengandingan Spesifikasi
| Parametr | SN65HVD08D | SN65HVD77D |
|---|---|---|
| Merek | Texas Instruments | Texas Instruments |
| Kategori | Interface ICs | Interface ICs |
| Status Lingkungan Hidup | Aktif | Aktif |
| Product Type | Half-duplex RS-485 transceiver | Full-duplex RS-485 transceiver |
| Tegangan Pemberi Arus | 3.3/5 V | — |
| Maximum Supply Voltage | 5.5 V | — |
| Maximum Data Rate | 10 Mbps | 50 Mbps |
| Quiescent Power Consumption | Less than 90 mW | — |
| Receiver Unit Load | 1/8 unit load | — |
| Maximum Bus Nodes | Up to 256 nodes | — |
| Bus-Pin ESD Protection | Exceeds 16 kV HBM | — |
| Driver Output Type | Three-state differential line driver | Differential |
| Receiver Type | Differential line receiver | — |
| Failsafe Receiver Behavior | Open-circuit, short-circuit, and idle-bus failsafe | — |
| Standards Compatibility | ANSI TIA/EIA-485-A and ISO-8482E | — |
| Cable-Powered Operation | 5-V power bus with up to 2 V line-voltage drop | — |
| Kemasan | 8-pin SOIC | 8-pin SOIC (D) |
| Jenis Pemasangan | Surface mount | Surface mount |
| Gambaran Suhu Operasi | [DATA_NEEDED: operating temperature range] | -40°C to 125°C |
| Status RoHS | [DATA_NEEDED: RoHS status] | Compliant |
| REACH Status | [DATA_NEEDED: REACH status] | — |
| Supply Voltage Range | — | 3.0 V to 3.6 V |
| Nominal Supply Voltage | — | 3.3 V |
| Number of Drivers | — | 1 |
| Number of Receivers | — | 1 |
| Duplex Mode | — | Full duplex |
| Supported Standards | — | RS-485 and RS-422 |
| ESD Protection | — | ±12 kV IEC |
| Package Width | — | 3.90 mm |
| External Enable Controls | — | None |
| Receiver Output Type | — | Single-ended logic output |
| Low-Power Standby Current | — | Less than 5 µA when driver and receiver are disabled |
| Termination Requirement | — | External termination required |