AD842JN vs AD8002ANZ 비교
다음의 상세 나란히 비교: AD842JN 제조: Analog Devices 및 AD8002ANZ 제조: Analog Devices. 주요 사양, 전기적 파라미터, 패키징, 수명 주기 상태, 가격 및 재고를 비교하여 설계 요구 사항에 가장 적합한 부품을 결정하십시오.
사양 비교
| 파라미터 | AD842JN | AD8002ANZ |
|---|---|---|
| 브랜드 | Analog Devices | Analog Devices |
| 카테고리 | Amplifier ICs | Amplifier ICs |
| 수명 주기 상태 | 활성 | 활성 |
| Product Type | Single wideband precision operational amplifier | — |
| Gain-Bandwidth Product | 80 MHz | — |
| Minimum Stable Gain | 2 | — |
| Supply Voltage Range | +/-5 V to +/-18 V | [DATA_NEEDED: supply voltage range] |
| Minimum Output Current Drive | 100 mA | — |
| Input Offset Voltage | [DATA_NEEDED: input offset voltage] | [DATA_NEEDED: input offset voltage] |
| Input Bias Current | [DATA_NEEDED: input bias current] | — |
| Slew Rate | [DATA_NEEDED: slew rate] | 1200 V/µs |
| Open-Loop Gain | [DATA_NEEDED: open-loop gain] | — |
| Common-Mode Rejection Ratio | [DATA_NEEDED: common-mode rejection ratio] | — |
| Power-Supply Rejection Ratio | [DATA_NEEDED: power-supply rejection ratio] | — |
| Input Noise Density | [DATA_NEEDED: input noise density] | — |
| Output Voltage Swing | [DATA_NEEDED: output voltage swing] | — |
| 동작 온도 범위 | [DATA_NEEDED: operating temperature range] | [DATA_NEEDED: operating temperature range] |
| 패키지 | 14-pin PDIP | 8-lead plastic DIP, 0.300 inch (7.62 mm) pitch |
| 실장 유형 | Through-hole | Through-hole |
| Process Technology | Junction-isolated complementary bipolar (CB) process | — |
| Short-Circuit Protection | [DATA_NEEDED: short-circuit protection] | — |
| RoHS 상태 | [DATA_NEEDED: RoHS status] | [DATA_NEEDED: RoHS status] |
| REACH Status | [DATA_NEEDED: REACH status] | [DATA_NEEDED: REACH status] |
| Amplifier Type | — | Current Feedback Amplifier |
| Number of Circuits | — | 2 circuits |
| Small-Signal Bandwidth at Gain +1 | — | 600 MHz (-3 dB) |
| Small-Signal Bandwidth at Gain +2 | — | 500 MHz (-3 dB) |
| Settling Time to 0.1% | — | 16 ns |
| Maximum Power Dissipation | — | 50 mW |
| Maximum Supply Current | — | 5.0 mA per amplifier |
| Nominal Supply Voltage | — | ±5 V |
| Gain Flatness | — | 0.1 dB to 60 MHz at gain +2 with RL = 150 ohm |
| Differential Gain Error | — | 0.01% |
| Differential Phase Error | — | 0.02 degrees |
| Packaging | — | Tube |
| Input Noise Voltage | — | [DATA_NEEDED: input noise voltage] |
| Output Current | — | [DATA_NEEDED: output current] |